L' ARTISTICO 40113 Manual De Instrucciones página 36

ENG
17. MOUNTING CERAMIC
The ceramics are provided disassembled to avoid breakage during transport and assembly of the stove. Handle with
great care to avoid damaging the ceramics. Below the procedure for mounting the corners and the cover of the stove:
1) Place the first ceramic corner into
the stove guides.
4) Paste the rubber at either end of
the angle ceramic.
7) Place the rear cover by inserting
the two pins in the holes on the
uprights of the stove.
Below the procedure for mounting the sides and top of the ceramic heater:
2) Guide the corner up to the
support bottom.
5) Place the second angular
ceramic.
8) Paying attention to the hands,
place the cover on the front where it
will be held in place by magnets
adjustable in height.
PELLET STOVES
3) Remove two silicone rubber from
the packaging ...
6) Repeat steps 1 through 5 for the
other side.
9) ) Open the cover of load pellet and
lock the cover to the rear uprights
with bolts supplied.
(Rev. 15/10/2013)