Volume level Vo3 flashes on the display.
• You can set the volume of the selected language using the func-
tion buttons
:
Vo3 = loud
Vo2 = medium
Vo1 = quiet
Confirm your selection with the Memory button .
Operation with the power supply unit
You can also operate this device with a power supply unit. When doing so, there must not be any batteries in
the battery compartment. The power supply unit can be obtained from specialist retailers or from the service
address using order number 071.30.
• To prevent possible damage to the device, the blood pressure monitor must only be used with the po-
wer supply unit described here.
• Insert the power supply unit into the connection provided for this purpose on the right-hand side of the
blood pressure monitor. The power supply unit must only be connected to the mains voltage that is spe-
cified on the type plate.
• Then insert the mains plug of the power supply unit into the mains socket.
• After using the blood pressure monitor, unplug the power supply unit from the mains socket first and
then disconnect it from the blood pressure monitor. As soon as you unplug the power supply unit, the
blood pressure monitor loses the date and time setting but the saved measured values are retained.
5. Measuring blood pressure
Please ensure the unit is at room temperature before measuring.
Attach the cuff
Place the cuff on to the
bare left upper arm. The
circulation of the arm
must not be hindered
by tight clothing or
similar.
Caution: The unit may only be operated with the original cuff. The cuff is suitable for an arm circumference
of 22 to 36 cm.
Adopt the correct posture
• Before every measurement, relax for about
five minutes. Otherwise deviations can occur.
• You can perform the measurement while
sitting or lying. Make sure that the cuff is at
heart level.
• To avoid falsifying the measuring result, it is
important to remain still during the measurement and not to speak!
All manuals and user guides at all-guides.com
The cuff must be placed
on the upper arm so
that the bottom edge
is positioned 2 – 3 cm
above the elbow and
over the artery. The line
points to the centre of
the palm.
Voice output
Now tighten the free end
of the cuff, but make
sure that it is not too
tight around the arm
and close the Velcro
fastener. The cuff should
be fastened so that two
fingers fit under the cuff.
15
Now insert the cuff line
into the connection for
the cuff connector.