Bionaire BCH9212 Manual De Instrucciones página 4

NOTE: Avoid overloading your circuit by not
using other high wattage appliances in the
same outlet.
3. Operate heater by pressing the Power
Button ( ) and selecting modes and
settings according to preference.
Power On/Off
Press the Power On/Off Button to turn the heater
on. Once on, the heater will run in the Max/2
mode and the Stay On icon will appear on the
LCD Display. Press the Power On/Off button to
manually turn off the heater at any setting.
NOTE: The Power Light will remain illuminated
while unit is plugged in.
Mode Selection
Select your desired heat settings by pressing the
corresponding buttons as located on your heater
or press the Mode button on remote control (if
applicable) to cycle through the heat settings. An
indicator light will illuminate next to each button
to indicate that the selected setting/mode is
activated.
NOTE: Settings and control buttons may vary
slightly between models.
Figure 6
BCH9212
D
C
BCH9221
A Control Buttons
B LCD Display
C Dial Wheel
All manuals and user guides at all-guides.com
A
B
E
D Power Light
E Remote Control
(if applicable)
Fan Only Setting
Press the Fan Only Button to run the heater
without heat output. The Stay On icon will
appear on the LCD Display.
Max or 2 – HIGH Heat Setting
Press the Max/2 Button to run the heater
continuously at 1500W. The Stay On icon will
appear on the LCD Display.
Low or 1 – LOW Heat Setting (if
applicable)
Press the Low Heat/1 Button to run the heater
continuously at 750W (1000W for fan-forced
heaters). The Stay On icon will appear on the
LCD Display.
Auto – Auto Setting (if applicable)
Press the Auto Button to activate the energy
efficient mode. The heater will now cycle
between high (at 1500W) and low (at 750W or
1000W for fan-forced heaters) heat settings to
provide heat. The Stay On icon will appear on
the LCD Display.
Thermostat Control
Your heater is equipped with a digital thermostat
that allows you to set your heater to a precise
comfort level by turning the Dial Wheel on the
control panel or pressing the arrow buttons on
the remote control (if applicable):
NOTE: If your heater comes with a Thermostat
Button ( ) on the control panel or remote
control (if applicable), you may either press the
button or turn the Dial Wheel to activate. The
Thermostat icon (
LCD Display.
To preset a precise comfort level, turn the Dial
Wheel to adjust the temperature from 30°C to
18°C (Default: "30"). The LCD Display will
show the selected temperature reading. When
the preset temperature is reached, the heater
will shut off and cool down for 15 seconds.
When the room temperature drops below the
preset temperature, the heater will automatically
turn on again to maintain the preset temperature
level.
FrostProtect Setting
Your heater is equipped with FrostProtect.
The heater will turn on automatically when the
room temperature drops below 5°C. To activate
FrostProtect, turn the Dial Wheel to show "5"
and the FrostProtect icon (
on the LCD Display.
NOTE: It is normal for the heater to cycle on
and off to maintain the preset temperature.
Raise the thermostat setting or operate in Stay
4
) will appear on the
) will appear