Getting Started; Button Operation - Pulsar AXION 2 LRF XQ Guia De Inicio Rapido

Getting Started

EN
Before first use, the battery
y
according to the diagram in the figure.
Insert the rechargeable battery
y
the battery compartment (14).
Open the lens cover (8). Secure the cover with to the strap
y
using the built-in magnet in the cover.
Press the ON/OFF button
y
Adjust the eyepiece diopter ring
y
display are sharp.
Rotate the lens focus ring
y
observed.
Enter the main menu with a long press of the MENU
y
button (4) and select the desired calibration mode: manual
(M), semi-automatic (SA) or automatic (A).
Calibrate the image by briefly pressing the ON/OFF button
y
(6) (if the SA or M calibration mode has been selected).
Close the lens cover when calibrating manually.
Select the required amplification level ("Normal", "High",
y
"Ultra") by briefly pressing the UP button (5).
Enter the main menu with a long press of the MENU
y
button (4) and select the appropriate colour palette (for
more details see the Main Menu section in the full version
of the manual).
Activate the quick menu by briefly pressing the MENU
y
button (4) to adjust the brightness, contrast and smooth
digital zoom of the display (see the Quick Menu section of
the full version manual for details).
Press the LRF button (12) briefly to start the rangefinder.
y
The rangefinder reticle will appear in the center of the
display. Briefly press the LRF button (12) to measure
10
(15) should be charged
(15)
along the guide into
(6)
briefly to turn on the device.
(1) until the symbols in the
(7) to focus on the object being
the distance. Press and hold down the LRF button (12) for 2
seconds to measure the distance in scan mode.
Upon completion of use turn the device off by a long press of
y
the ON/OFF button (6).

Button Operation

(6) ON/OFF button
Device is off: Power on the device: short press of the ON/OFF
button (6).
Device is on: Power off the device: long press of the ON/OFF
button (6) for longer than 3 seconds.
Turn display off: long press of the ON/OFF
button (6) for less than 3 seconds.
Turn display on: short press of the ON/OFF
button (6).
Microbolometer calibration: short press of the
ON/OFF button (6).
(3) DOWN/REC button
Device is in
Start /pause/resume video recording: short
Video mode: press of the DOWN/REC button (3).
Stop video recording: long press of the DOWN/
REC button (3).
Switch to Photo mode: long press of the DOWN/
REC button (3).
QUICK START GUIDE