Philips Vision Plus HR8907/02 Manual Del Usuario página 4

English
• To enable recycling, the plastics of
the product have been coded.
• The cardboard packaging has been
made of recycled material and is entirely
suitable for recycling.
Important
• Before using for the first time, check
if the dustbag is placed correctly.
• Never suck up water (or any other
liquid). Never pick up ashes until they
are cold.
• When picking up fine dust, the pores
of the dustbag may become clogged.
This will obstruct the air passage.
Subsequently, the dustbag needs
replacement, although the bag might
be far from full.
• Only use this vacuum cleaner with
the original paper dustbags type
Philips Oslo + or Oslo + Hygiene
(closeable).
• Never use the vacuum cleaner
without the Active Carbon filter
and/or the dustbag!
Getting the vacuum cleaner ready for use:
• Connecting the hose: press firmly
("Click!") (fig. 1).
- To disconnect: press the knob (1) and pull
(2) the hose out of the vacuum cleaner
(fig. 2).
• Connecting the nozzle, the telescopic
tube and the handle: insert the narrowed
section into the wider section while rotating a
little (fig. 3).
- To disconnect: pull while rotating.
• To adjust the telescopic tube to the
required length: grasp the plastic ring and
pull out the upper tube as far as necessary
(fig. 4). Lock the telescopic tube in position by
releasing the plastic ring.
All manuals and user guides at all-guides.com
• Nozzles:
f
• Pull the mains plug out of the vacuum
• Press the on/off switch (
• The electronic suction power control on
• The suction power control at the hand
Insufficient suction power?
Please check:
- if the slide on the vacuum cleaner is in the
- if the control at the hand grip is in "open"
- if the dustbag is full;
- if the nozzle, tube or hose is blocked up.
Automatic suction power control
The automatic suction power control adjusts the
suction power to the type of floor (hard floor or
carpet) and when the dustbag becomes full.
Automatic suction power control is advisable for
general use on floors.
- Press button "AUTOMATIC" to activate
4
- Combi nozzle. This nozzle is convertible
for use on either carpets (without brush,
fig. 5) or hard floors (with brush, fig. 6);
- Small nozzle, brush nozzle and crevice
nozzle. These can be found in the special
storage compartment (fig. 7-11);
cleaner (fig. 12) and insert into the wall
socket.
the vacuum cleaner enables smooth suction
power adjustment (fig. 14).
Medium suction power is advisable for
general use.
Minimum suction power is advisable for
dusting using the brush nozzle and for cleaning
curtains, cloths, etc.
Maximum suction power is advisable for
cleaning very dirty carpets and hard floors.
grip enables you to reduce suction power
(fig. 15). This extra facility is advisable if you
wish to apply lower suction power for a short
period.
required position;
position;
To remove the obstruction, disconnect the
blocked-up item and connect it (as far as
possible) in adverse position. Then the air will
stream through the item in opposite direction.
automatic suction power control (fig. 16).
I ) (fig. 13).