Pleasant Hearth Taylor Manual página 5

ASSEMBLY INSTRUCTIONS
4. Insert 4 dowels (CC) into pre-drilled holes in
base (C) and 4 dowels (CC) into top edge of
inner panel assembly. Slip previous assembly
over all dowels (CC) until snug. Secure with
bolts (AA) and washers (BB) inserted through
pre-drilled holes as illustrated. Tighten with
screwdriver.
5. Set top panel (A) on top of assembly. Secure
from the inside with bolts (AA) and washers
(BB) through predrilled holes as illustrated.
Tighten with screwdriver.
6. Attach upper back panel (G) by dropping into
place using magnetic backing as illustrated.
Attach both lower back panels (M) by placing
screws (DD) through predrilled holes as shown
and tightening with screwdriver.
4
5
BB
AA
6
5
C
A
L
M
DD
M
BB
AA
CC