Weighing Mode; Other Remarks - Terraillon TFA1 5 Manual Del Usuario

All manuals and user guides at all-guides.com
TFA15 mnl BAT 16/12/03
TFA15 - TFA 20 - TFA 25
ELECTRONIC BATHROOM SCALE - BODY FAT ANALYZER
9. Step onto the scale in your bare feet. Do not move
during weighing. Your weight will be displayed for 3
seconds.
10. Then the scale will begin calculating your rate of body
fat. The screen will display rapidly blinking zeros.
11. This phase ends with a beep. The percentage of fat,
the weight, the age and the sex appear for 4 seconds.
The scale switches off automatically.
To use your memory:
1. Press the [ ON/OFF ] button to access the impedance
measurement mode.
2. Press the " MEMORY" [ MEM. ] button to select the
memory mode and obtain a data display.
3. Press the [ ] buttons to select the memory where
/
your data is stored. If the selected memory is empty,
no data will appear; if it is full, the information it
contains will be displayed.
[ ]
4. Press the " ENTER"
to validate your choice of
memory. The scale will emit a beep.
5. Then follow instructions contained in steps 9 - 11 above.

2) Weighing Mode

1. Step onto the platform.
2. Do not move during weighing.
3. Your weight will be displayed on the screen as follows:
56.8
(56 kg 800 g)
17:24 Page 7
SPECIAL DISPLAYS
Display
Err0
Err1
Err2
Err3
Err4
Batt

OTHER REMARKS

1. The rate of body fat recommended by health care
professionals is :
2. Consult your doctor if your rate of body fat is below
or above normal.
3. Your percentage of body fat may vary from one day
to the next or depending on the time of day.
4. It is recommended to weight oneself regularly and
always under the same conditions.
WARRANTY
This impedance scale is guaranteed for 2 years against
defects in materials or manufacturing. During this period,
any such defects will be repaired free of charge (proof of
purchase must be shown in the case of a complaint under
warranty).
The warranty does not cover damage resulting from impro-
per use or negligence. In the event of a claim, first contact
the shop where you purchased your scale.
In the case of:
Incorrect initialisation: begin again as
explained above.
Unstable weight: begin again.
Overload: remove weight immediately.
Body impedance exceeds the limit
(100 ohm - 1kohm): begin again.
Percentage of body fat above
the 5%-50% bracket: begin again.
Battery failure: replace it.
Men: between 10% and 18%
Women: between 20% and 29%
7