CAUTION
Both control levers must be touching the fl oor
to prevent the refrigerator from tipping over and
causing personal injury or property damage.
CAUTION
If the refrigerator is installed on an uneven fl oor, it
may tilt. To prevent this, adjust the control levers
on both front legs so that they contact the fl oor
fi rmly.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is diffi cult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever.
Instead, refer to the next page for the best
way to make minor adjustments to the
doors.
MAKING MINOR ADJUSTMENTS
TO THE DOORS
A leveled refrigerator is necessary for getting the
doors perfectly even.
For leveling instructions, review the previous
section on leveling the refrigerator.
Fixed part
Fixed part
The left door is fi xed.
To make minor adjustments between
doors, adjust only the right door.
DA68-03030A-01.indb 16
DA68-03030A-01.indb 16
All manuals and user guides at all-guides.com
1. Pull out the freezer drawer ( 1 ) to reveal the
2. Insert the supplied allen wrench (5/32" (4 mm))
3. Adjust the height by turning the hex wrench
MAKING MINOR ADJUSTMENTS
BETWEEN OUT DOOR AND IN
DOOR
After raising the out door, insert the supplied SHIM
HINGE MIDDLE in the gap between the OUT
DOOR and the HINGE-SHAFT.
Adjustment
Adjustment
part
part
Keep the Rings out of the reach of children and
make sure that children do not play with them or
put them into their mouths.
English - 16
lower hinge ( 2 ).
( 3 ) into the shaft ( 4 ) of the lower hinge.
( 3 ) clockwise (
DOWN
DOWN
) or counter clockwise
UP
UP
(
).
(2)
(2)
(3)
(3)
(4)
(4)
(1)
(1)
When you turn the hex wrench counter-
clockwise (
), the door will move up.
SHIM HINGE MIDDLE are enclosed with
the refrigerator.
The thickness of RING is 0.04" (1 mm).
CAUTION
(3)
(3)
2014. 5. 13.
2014. 5. 13.
2:15
2:15