Completing The Set Up - Samsung RF30HB Manual Del Usuario

1. Connect the household water line to the
assembled compression fi tting.
- If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and
ferrule (not supplied) on the copper tubing (not
supplied) as shown.
- If you are using plastic tubing ( B ), insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fi tting.
CAUTION
Do not use without the molded end (Bulb) of the
plastic tubing ( B ).
2. Tighten the compression nut ( B ) onto the
compression fi tting.
Do not over-tighten the compression nut ( B ) .
3. Turn the water on and check for any leakage.
If you fi nd water drops or leakage in the
connection areas, turn off the main water
supply. Check the connections and, if
necessary, tighten.
4. Flush 1 gallon of water through the fi lter before
drinking or using the water from the refrigerator.
(Flush approximately 6 minutes.)
To fl ush, press a large glass or cup against the
water dispenser lever.
Fill the glass, empty it into the kitchen sink after
it is fi lled, and then repeat.
5. After you turn on the refrigerator, let the ice
maker make ice for 1 to 2 days.
Over that period of time, throw out the fi rst 1 or
2 buckets of ice the freezer makes to ensure all
impurities have been removed from the water
line.
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the
water line, cut off 1/4" of the plastic tubing
to make sure you get a snug, leak-free
connection.
You can test the water line quickly using a
paper cup. Under normal conditions, the
water dispenser can fi ll a 5.75 oz. (170 cc)
cup in about 10 seconds.
DA68-03030A-01.indb 18 DA68-03030A-01.indb 18
All manuals and user guides at all-guides.com

COMPLETING THE SET UP

Now that you have your new refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
1. Make sure your refrigerator is in an appropriate
2. Once the refrigerator is plugged in, make sure
3. Set the Temperature control to the coldest
4. After you plug the refrigerator in, it will
English - 18
location with reasonable clearance between it
and the wall. Refer to installation instructions in
this manual.
the interior light comes on when you open the
doors.
temperature and wait for an hour.
The freezer will get slightly chilled and the motor
will run smoothly.
Reset the refrigerator and freezer to the
temperatures you want.
take a few hours to reach the appropriate
temperature.
You can store food and drinks in the refrigerator
after the temperature is suffi ciently cool.
If condensation or water drops appear
on both sides of the fridge door's central
part, turn the Energy Saver mode off after
removing the condensation.
(See the explanation of the Energy Saver
button in "Using the Control Panel" on
page 19.)
2014. 5. 13. 2014. 5. 13. 2:15 2:15