Connecting The Drain Hose; Electrical Connections; The First Wash Cycle; Technical Data - Ariston WML 821 Manual De Instrucciones

Connecting the drain hose

!
We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.

Electrical connections

Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable
laws;
• the socket is able to withstand the maximum power
load of the appliance as indicated in the Technical data
table (see opposite);
• the power supply voltage falls within the values indica-
ted in the Technical data table (see opposite);
• the socket is compatible with the plug of the washing
machine. If this is not the case, replace the socket or the
plug.
!
The washing machine must not be installed outdoors,
even in covered areas. It is extremely dangerous to leave
the appliance exposed to rain, storms and other weather
conditions.
!
When the washing machine has been installed, the elec-
tricity socket must remain within easy reach.
!
Do not use extension cords or multiple sockets.
All manuals and user guides at all-guides.com
Connect the drain hose, wi-
thout bending it, to a drain
duct or a wall drain situated
between 65 and 100 cm
from the floor;
alternatively, placed it over
the edge of a basin, sink
or tub, fastening the duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.
!
The cable should not be bent or compressed.
!
The power supply cable must only be replaced by autho-
rised technicians.
Warning! The company shall not be held responsible in the
event that these standards are not observed.

The first wash cycle

Once the appliance has been installed, and before you use
it for the first time, run a wash cycle with detergent and no
laundry, using the programme "Auto Clean" (see "Cleaning
the washing machine").

Technical data

Model WML 821
width 59.5 cm
Dimensions height 85 cm
depth 60.5 cm
Capacity from 1 to 8 kg
Electrical
please refer to the technical data plate
fixed to the machine
connections
maximum pressure 1 MPa (10 bar)
Water connections minimum pressure 0.05 MPa (0.5 bar)
drum capacity 62 litres
Spin speed up to 1200 rotations per minute
Test wash cycles
in accordance
programme 4; temperature 60°C;
programme 5; temperature 40°C.
with directive
1061/2010
This appliance conforms to the following
EC Directives:
- 2004/108/EC (Electromagnetic Compa-
tibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC
GB
3