Building Into Fitted Kitchen Units - EAS ELECTRIC EMH46RN Manual De Instrucciones

Building into fitted kitchen units

These hobs are designed for instal-
lation in fitted kitchen units up to
600mm deep with suitable charac-
teristics.
Any cabinet side panels taller than
the height of the hob itself must be
at least 150mm away from the
opening into which the hob is
inserted.
The dimensions of the hob and the
installation opening are shown in the
illustration.
Insertion and fixing
B efore inserting the hob in the
installation
special gasket around the bottom
edge of the hob.
It is important to fix this gasket
evenly, without gaps or overlap-
ping, to prevent liquid from seeping
underneath the hob.
1) Remove the pan stands and
the burner caps and turn the
hob upside down, taking care not
to damage the ignition plugs
and the thermocouples.
2) Place the gasket around the
bottom edge of the hob as
shown in the illustration on the
right.
3) Place the hob in the installation
opening and push it down so
that the hob is resting firmly on
the cabinet, as show in the
illustration. The side springs will
hold it in place.
opening, place the
16 V.1