Stop The Machine; Adjust The Discharge Chute; Adjust The Chute Deflector - GreenWorks SNC407 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
1. While holding the safety switch button (14), pull the bail
lever (2) to start the machine.
2. LED headlights (9) will automatically turn on when unit
is started.
Lower the scraper to the ground to remove the snow.
Keep bystanders a safe distance from the machine.
Examine the work area. Remove all stones, sticks, wire,
bones, and other debris that can ricochet because of the
rotating impeller.
8.4

STOP THE MACHINE

2
1. Release the bail lever (2) to stop the machine.
2. At the same time, the LED lights (9) can be turned off.
Wait until the impeller fully stops before you start the
machine again. Do not quickly turn the machine off and on.
Remove the battery after you complete the work.
NOTE
WARNING
WARNING
WARNING
WARNING
English
8.5

ADJUST THE DISCHARGE CHUTE

10
You can adjust the discharge chute 180° to change the snow
direction.
1. Turn the grip handle (3) left to move the discharge chute
(10) to the right.
2. Turn the grip handle (3) right to move the discharge chute
(10) to the left.
8.6

ADJUST THE CHUTE DEFLECTOR

12
You can adjust the chute deflector up and down to change the
throwing distance of the snow.
Release the bail switch before you adjust the chute
deflector.
Do not push the deflector so far forward that a gap shows
between the deflector and the chute.
1. Push and hold the trigger on the chute deflector.
2. Move the chute deflector (12) up to increase the snow
distance.
3. Move the chute deflector (12) down to decrease the snow
distance.
10
3
WARNING
WARNING

Publicidad

Tabla de contenido
loading

Tabla de contenido