Store The Machine; Troubleshooting - GreenWorks SNA107 Manual Del Operador

EN
3. Remove the 5 screws (24) and side wear pad(26) that
secure the left side cover (31).
4. Remove the belt (28).
5. Using a socket wrench, remove the large pulley (29).
6. Remove the screws (24) that secure the left side plate.
English
7. Pull the axle (30) and remove the old impeller, install the
new impeller.
8. Reinstall the nut (27) and right side cover.
9. Reinstall the left side plate (32), large pulley (29), belt
(28) and left side cover (31).
8.4
• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
•
•
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
9
24 Problem
The handle is not
in position.
12
27
32
29 27
28

STORE THE MACHINE

Replace the damaged parts.
Tighten the bolts.
Speak to a person at an approved service center.

TROUBLESHOOTING

Possible cause
The bolts are not
engaged correctly.
30
31 26
24
Solution
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.