Time Zone Setting - Explore Scientific RDC1004 Manual De Instrucciones

and date setting.
3. The setting parameter will flash.
4. Press [UP] button once, the figure will in-
crease 1 unit (when setting minute, second
will reset to 0). Press and hold the [UP] but-
ton, the figures will increase rapidly.
5. Press [DOWN] button once, the figure will de-
crease 1 unit (when setting minute, second
will reset to 0). Press and hold the [DOWN]
button, the figures will decrease rapidly.
6. Press [SET] button to confirm setting and
enter to next parameter.
7. Sequence of setting: Time Zone +/-12h 
Time format 12/24h  Hour  Minute 
Year  Month  Date  Exit
8. If there is no action in 30 seconds, the setting
will be saved and will exit the setting mode.

TIME ZONE SETTING

To set a different time zone, proceed as follows:
1. Press and hold [SET] button to enter time
and date setting.
2. Press [+] or [–] button to set the time zone
offset +/-12 hours.
5. Press [SET] button several times until you
exit the setting mode.
°C/°F SETTING
1. Press [DOWN] button to switch Celsius (°C)
/ Fahrenheit (°F).
ALARM
SETTING/ADJUSTING ALARM TIME
1. Press and hold [AL.SET] button to enter the
alarm setting mode.
3. The setting parameter will flash.
4. Press [UP] or [DOWN] button to set the de-
sired data.
5. Press [AL.SET] button to confirm setting
and enter to next parameter.
EN
IT
DE
FR
ES
9