EAS ELECTRIC EHH210 Manual De Instrucciones página 26

ON/OFF
Under standby mode, press the " " button, the heater enters into the Normal
mode, works with highest power, and automatically set the temperature at
35ºC, repeatedly press the "
> Off > High.
Mode switch
Under working state, press the "
heating mode > Energy saving mode > Anti-Freezing mode > Normal mode.
Timing ON
Under Off state, press the "
the setting time and timing icon flashed, turn the knob to adjust the setting
time, it will automatically exit the enquiry setting interface if it is not
operated within 3s. When the setting is 0, it cancels timing On. After reaching
the timing On time, the heater automatically turns on and works at the last
standby state. The time setting range is 0-24H, the adjustment step is 1h.
Timing OFF
Under On state, press the "
the timing enquiry interface, turn the knob to adjust the setting time, it will
automatically exit the enquiry setting interface if it is not operated within 3s.
When the setting is 0, it cancels timing Off. After reaching the timing Off
time, the heater automatically enters into the standby state and stops
working. The time setting range is 0-24H, the adjustment step is 1h.
+ and -
When working mode is ON, press the "
temperature within 5 to 35ºC.
Introduction on modes
Fast-heating mode
and setting temperature are not adjustable. The heater works at default
setting temperature (35°C) and the indicator light circle indicates red.
Energy Saving mode ECO: under this mode, the heater works normally, the
level and setting temperature are not adjustable, the heater works at default
setting temperature (22ºC). (ln Energy saving mode, if the setting tem-
perature flashes, it means the heater is under energy saving heat preser-
vation work state). The indicator light circle indicates green.
Anti-Freezing mode
but the setting temperature is not adjustable, the heater works at default
anti-freezing temperature (5ºC). (ln Anti­freezing mode, if the setting
temperature flashes, it means the heater is under anti-freezing heat preser-
vation work state). The indicator light circle indicates orange.
" button to switch between High > Middle > Low
" button, the heater switches between Fast
" button to enter the timing enquiry interface,
" button (or remote controller button) to enter
: under this mode, the heater works normally, the level
: under this mode, press the knob to adjust the level,
10
" button, press "+" or "-" to adjust
V.1