EAS ELECTRIC EHH210 Manual De Instrucciones página 27

Memory function
When the power of the heater is not cut off or the heater keeps under
Standby mode, it can memorize the last working mode and setting
temperature and works at the setting temperature after turning on. The
memory data will be reset if the power supply of the heater is cut off, and the
setting temperature of the heater recovers to the default setting (Normal
Mode, high, setting temperature is 35°C) when turning on.
Using the remote control
There are six function buttons on remote control. Functions are as follows:
Symbol
Function
ó
Display & function On/Off
�
Heating mode: Hi/Med/Low
0
Timer setting
lncrease the temperature and timer setting
A
Decrease the temperature and timer setting
y
Mode setting
M
The remote control functions are same as the buttons on the heater body, it
allows you to operate more easily. When using remote control, it should be
aimed at the receiving window of the unit. Effective distance is around 6
meters.
Point the remote control towards the heater and press the
remote control does not operate the unit when pointed directly at it, replace
the battery.
Inserting the batteries
1. Press down on the battery compartment cover and slide it out.
2. Insert the batteries, making sure that the positive terminals are facing the
proper direction marked inside the battery compartment.
3. Close the cover by sliding it in.
Note:
1. Use 2 "AAA" batteries (not included).
m
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-line) or rechargeable
(nickel-cadmium) batteries.
4. Remove the batteries from the remote controller if it is to be left
unused for a long period of time.
11
@@
0@
0@
button. lf the
V.1