How To Make Cappuccino - ARIETE Cialdissima Manual Del Usuario

how to make coffee with a pod
To make coffee with pods you must use the specific pod filter (U) that came with the coffee maker as described below:
1 Put the drip tray (W) and pod filter (V) inside the filter holder (U).
2 Place the pod in the filter ring (Fig. 14).
3 Push the pod towards the bottom of the filter with your fingers (Fig. 15).
4 The pod must be well centred and placed inside the filter.
5 Now it is possible to put the filter holder in its seat. Tighten the filter holder while making sure you have hooked it properly
onto the flange (Fig. 6).
6 The pod could remain stuck in the upper part of the machine after making the coffee and when removing filter holder. To
remove it, tilt the filter holder (Fig. 16) so the pod can fall onto it.
In order to always get an excellent cup of coffee, buy the pod that bears the E.S.E. compatibility mark.
If the pod is not inserted well, or if the filter holder is not tightened firmly, a few drops of water could leak from the
filter holder.
Filling the water tank during use
No special operation is necessary when the water in the tank runs out as the machine is equipped with a special self-priming
device. Just unplug the machine, pull out the tank and fill it with fresh cool water again.

hOW TO MAke cAppuccInO

To prepare a cappuccino or hot chocolate or to heat any other beverage, press the switch (T); the indicator lamp (S) turns
on. When it turns off, the machine will be ready to generate steam.
When warming up, your appliance may release small puffs of steam from the filter holder; this is perfectly normal.
Now open the steam dispensing cock (P) anti-clockwise, having the foresight to position a cup underneath the Maxi Cappuc-
cino device (E) Fig. 8: at first a little water will come out, immediately followed by a strong jet of steam.
Plunge the wand all the way into the pot of milk (Fig. 9) and open the dispensing cock (P). During these operations you may
notice that the warning light (S) goes on and off from time to time, indicating that the boiler thermostat is keeping the water
required for the steam supply at the right temperature.
it is opportune you start dispensing the steam only when this indicator lamp is off. dispense the steam for a few
seconds after every use in order to free the hole of any milk residue.
After the cappuccino is prepared, press the switch (T) to cut out the steam function.
MAkIng FurTher cups OF cOFFee
To prepare a cup of coffee right after making cappuccino, it is necessary to bring the boiler back to the coffee preparation
temperature by performing these operations: press the steam function switch (T). You may notice that the indicator lamp (S)
is on. This luminous indication serves to tell you that the temperature in the boiler is still high, i.e. it is still that for steam; you
must therefore wait a few seconds until the lamp (S) turns off. If you want to cool down the boiler faster, place a container
underneath the cappuccino maker, press switch (R) and at the same time keep the cock (P) open; Make water come out of
the Maxi Cappuccino device until when the indicator lamp (S) turns back on; Now close the cock (P) and turn the switch (R)
off. Wait for the lamp (S) to turn off before making another cup of coffee.
hOW TO MAke TeA Or TIsAnes
When the machine is in the coffee-ready position, i.e. with the lamp (S) off, place a cup underneath the spout (E) and press
the coffee dispensing switch (R). Open the steam dispensing cock (P) immediately afterwards; in this way hot water will
come out of the spout. The maximum quantity for two cups is 200 ml.
useFul TIps FOr ObTAInIng A gOOD ITAlIAn espressO
The ground coffee in the filter holder has to be pressed lightly. Whether the coffee is stronger or weaker depends on the
degree the coffee is ground, the quantity put into the filter holder and the pressing. Just a few seconds are needed for the
coffee to flow down into the cups. If the dispensing time is longer, this means that the coffee is ground too fine or that the
coffee put into the filter holder has been pressed too much.
14