Important Safety Instructions For Battery Charger - Metabo HPT UB 18DD Instrucciones De Seguridad Y Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10. Do not use the product if the tool or the
battery terminals (battery mount) are
deformed.
Installing the battery could cause a short circuit
that could result in smoke emission or ignition.
11. Keep the tool's terminals (battery mount)
free of swarf and dust.
Prior to use, make sure that swarf and dust
have not collected in the area of the terminals.
During use, try to avoid swarf or dust on the tool
from falling on the battery.
When suspending operation or after use, do
not leave the tool in an area where it may be
exposed to falling swarf or dust.
Doing so could cause a short circuit that could
result in smoke emission or ignition.
IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CHARGER
WARNING
Death or serious bodily injury could result
from improper or unsafe use of battery
chargers. To avoid these risks, follow
these basic safety instructions:
READ ALL INSTRUCTIONS
1.
This manual contains important safety and
operating instructions for battery charger
Model UC18YFSL.
AC Input Rating Amperes*
Equal to or
greater than
0
2
3
*
If the input rating of a battery charger is given in
watts rather than in amperes, the corresponding
ampere rating is to be determined by dividing
the wattage rating by the voltage rating–for
example:
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
but less
than
2
3
4
2.
Before using battery charger, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product
using battery.
3.
To reduce risk of injury, charge metabo HPT
rechargeable battery models of the multi volt
series and the BSL18 series. Other models of
batteries may burst causing personal injury
and damage.
4.
Use of an attachment not recommended or
sold by the battery charger manufacturer may
result in a risk of fi re, electric shock, or injury to
persons.
5.
To reduce risk of damage to electric plug and
cord, pull by plug when disconnecting battery
charger.
6.
Make sure cord is located so that it will not
be stepped on, tripped over, or otherwise
subjected to damage or stress.
7.
An extension cord should not be used unless
absolutely necessary. Use of improper
extension cord could result in a risk of fi re and
electric shock.
If extension cord must be used make sure:
a. That blades of extension cord are the same
number, size, and shape as those of plug
on battery charger:
b. That extension cord is properly wired and
in good electrical condition; and
c. That wire size is large enough for AC
ampere rating of battery charger as
specifi ed in Table 1.
Table 1
AWG Size of Cord
Length of Cord, Feet (Meter)
25 (7.5)
50 (15)
18
18
18
1,250 watts
125 volts
100 (30)
18
18
18
16
18
16
= 10 amperes
English
150 (45)
16
14
14
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ub18ddq4m

Tabla de contenido