Hansgrohe AXOR Citterio 39850 Serie Instrucciones De Montaje página 8

Important! The fitting must installed, flushed and
tested after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose
and threaded base and tighten the collar nut
by hand. If there is not enough space, please
use only the slide washer and the metall
without the plastic washer.
4. Tighten screws.
5. Connect the connecting hose / supply pipes to
the angle valves; cold right ­ hot left.
The hot and cold supplies must be of equal pres­
sures.
Technical Data
Operating pressure:
Recommended operating pressure: 0,1 ­ 0,5 MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.: 65° C
Rate of flow:
Test certificate:
Operation
close

English
max. 1 MPa
1,6 MPa
max. 80° C
13 l/min 0,3 MPa
WRAS
open
Hansgrohe single lever mixers can be used togeth­
er with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPas.
To adjust the hot water limiter on single lever
mixers, please see page 15.
No adjustment is necessary when using a conti­
nuous flow water heater.
Spare parts (see page 3)
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 aerator cpl.
6 fixation cpl.
7 connection hose 900 mm
8 spout cpl.
9 sealing set
XXX = Colors
000 chrome plated
800 steel
cold
39891XXX
96338000
98603XXX
96461000
92730000
97691XXX
95049000
96316000
98604XXX
92646000
hot