Operation - Hilti AG 125-A22 Manual De Instrucciones

1. Pull the battery out of the tool.
2. CAUTION The clamping flange is equipped with
an O-ring. The O-ring must be replaced if miss-
ing or damaged.
Fit the clamping flange onto the drive spindle.
3. Fit the diamond disc, cutting disc or grinding
disc.
en
4. Screw on the clamping nut and tighten it.
5. CAUTION Do not press the spindle lockbutton
before the drive spindle has stopped rotating.
Press the spindle lockbutton and hold it in this
position.
6. Use the wrench to tighten the clamping nut
securely and then release the spindle lockbutton.
6.9 Using the Kwik-Lock clamping nut with
grinding / cutting discs
6.9.1 Fitting grinding / cutting discs using the
Kwik-Lock clamping nut 8
NOTE
The Kwik-Lock nut may be used instead of the stand-
ard clamping nut. No tools are then required for
changing cutting discs.
NOTE
The Kwik-Lock nut cannot be used with cup wheels,
brushes, rubber backing pads, tuck pointing discs
(special discs used for joint repair) or with diamond
cup wheels.
CAUTION
When operating the power tool, take care to ensure
that the Kwik-Lock nut does not come into contact
with the work surface. Do not use a damaged Kwik-
Lock nut.

7. Operation

WARNING
Wear personal protective equipment. Exposure to
noise can cause hearing loss.
34
Printed: 31.07.2012 | Doc-Nr: PUB / 5071441 / 000 / 00
All manuals and user guides at all-guides.com
NOTE
The arrow on the upper surface of the nut must be
within the index marks. If the arrow is not within
the index marks when the nut is tightened it will be
impossible to release the nut by hand. In this case,
use the pin wrench to release the Kwik-Lock nut (do
not use a pipe wrench!).
1. Pull the battery out of the power tool.
2. Clean the clamping flange and the quick-release
clamping nut.
3. CAUTION The clamping flange is equipped with
an O-ring. The O-ring must be replaced if miss-
ing or damaged.
Fit the clamping flange onto the drive spindle.
4. Fit the diamond disc, cutting disc or grinding
disc.
5. Screw the quick-release clamping nut onto the
spindle until it contacts the disc (the side with
the lettering should be visible after the nut is
screwed on).
6. CAUTION Do not press the spindle lockbutton
before the drive spindle has stopped rotating.
Press the spindle lockbutton and hold it in this
position.
7. Use the wrench to tighten the clamping nut or,
respectively, rotate the grinding disc firmly by
hand in a clockwise direction until the Kwik Lock
nut is tight, and then release the spindle lockbut-
ton.
6.9.2 Removing grinding / cutting discs secured
with the Kwik-Lock nut
1. Disconnect the supply cord plug from the power
outlet.
2. Release the Kwik-Lock nut by turning the knurled
ring in a counterclockwise direction. (Use the pin
wrench to release the Kwik-Lock nut if very tight.
Do not use a pipe wrench.)
WARNING
Test new cutting or grinding discs by allowing them
to run at maximum speed in a protected area for at
least 30 seconds.