Operation; Switching On And Off - Hilti AG 230-S Manual De Instrucciones

7. Operation

● The supply voltage must comply with the information printed on the rating plate on
the tool. Tools with a voltage rating of 230 V may also be connected to a 220 V supply.
● The side handle must always be fitted when the tool is in use.
● Use clamps or a vice to secure a loose workpiece.
7.1 Structural design considerations
Slits in load-bearing walls are subject to part 1 of the DIN 1053 standard, or other
national regulations and directives. It is essential that these regulations are observed.
The design engineer, architect, or person in charge of the building project must be
consulted before beginning cutting or slitting work.
7.2 Operation
-NOTE-
Test new cutting or grinding discs by allowing them to run at maximum speed for at
least 30 seconds.
-CAUTION-
Never use cutting discs for grinding.

7.3 Switching on and off

1. Plug the supply cord into the electric socket.
2. Switch on by operating the on / off switch.
Switching on:
Slide the on / off switch forward without applying pressure and then press the switch.
Switching off:
Release the on / off switch.
22
Printed: 07.07.2013 | Doc-Nr: PUB / 5069436 / 000 / 00
■ The material may splinter during cutting or grinding.
■ Splintering material may injure parts of the body and the eyes.
■ Wear eye protection, protective gloves and breathing protec-
tion if a dust removal system is not used.
■ Operation of the tool creates noise.
■ Excessive noise may damage the hearing.
■ Wear ear protection.
-CAUTION-
-CAUTION-