Parts And Components; Before Use; Product Assembly - cecotec BIGDRY 5000 ADVANCE CONNECTED Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Display
2. Power button
3. Humidity button
4. Mode button
5. Speed button
6. Timer
7. Safety child lock
8. Air Clean mode
9. Sleep mode
10. Full tank indicator
Fig. 2
1. Display
2. Water tank
3. Air vent
4. Handle
5. Carbon filter (Hacer drawing)

2. BEFORE USE

Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If any sign of visible
damage is observed, contact immediately with our official Technical Support Service.
When installing the device, ensure a minimum safety distance of 20 cm to each of its sides.

3. PRODUCT ASSEMBLY

Leave 20 cm or more of space to the left and to the right of the device and 30 cm on top of it.
Fig. 3
The device will not operate if the water tank is full or not correctly assembled.
To remove the water tank, hold it and pull it out.
Fig. 4
The device has a carbon filter which is already installed. This filter captures dirt, harmful
particles and bad odours. In order to ensure an optimum operation, follow the instructions on
28 BIGDRY 5000 ADVANCE CONNECTED
the Cleaning and maintenance section.
Emptying the water tank
Remove the water tank from the device.
Pour out the water inside it.
Install the water tank back again into the dehumidifier.
4. OPERATION
Control panel
Power button
Use this button to switch the device on and off.
Mode button
Press this button to select a mode. The current mode's button will flash. The device has
four modes: Dehumidification, Automatic dehumidification, Forced dehumidification and Dry
clothes. Press the corresponding button to the function you want to activate and, after 5
seconds, it will enter the selected mode.
Air-speed button
Set then air speed to "low" or "high". The corresponding indicator light will turn on.
Timer
Set the timer from 1 to 24 hours. The device will automatically exit this mode if the user
chooses "0" or after 5 seconds of no operation.
Press this button to activate the timer and press it repeatedly to check the selected time.
After the timer has been set, press this button again to display the remaining time.
Humidity settings
Set the humidity percentage by pressing this button. It goes from 30 to 80, from 5 % to 5 %.
Air Clean function
Press this button to turn the Air Clean function on.
Safety child lock
Press this button to activate the child-safety lock.
Wi-Fi mode
To activate the Wi-Fi mode, hold down the mode button for 5 seconds.
ENGLISH
BIGDRY 5000 ADVANCE CONNECTED 29