Kinderkraft LIVY Manual De Uso página 35

the body of the bouncer on a clean, level surface so that the adapters are at the top. Unfold
the adapters – pull them towards the outside of the bouncer (fig. B). The correct locking of the
adapters is indicated by the click of the latches on the frame of the bouncer. Then slide the
adapters of the bouncer onto the legs, correct installation is characterised by a click (fig. C).
1.B. Assembling the high bouncer*:
Place one of the front legs (4) on a flat surface so that its smooth part is visible. Insert the nuts
(17) into the holes located on the shorter leg member (fig. D I). Slide the leg (4) into the back
legs (5) (fig. D II) and screw them together with two bolts 15 B using an Allen key (16). Repeat
with the other front leg and bring the structure upright (fig. E). Make sure that the screws are
properly tightened and the structure is stable. Slide the footrest (6) between the legs of the
chair (the metal pieces on the sides of the footrest should slide into the grooves on the legs)
and set at the bottom of the legs at the level of your choice (fig. F). Connect the footrest to the
legs using two bolts 15 A. Place the body of the bouncer on a clean, level surface so that the
adapters are at the top. Unfold the adapters – pull them towards the outside of the bouncer
(fig. B). The correct locking of the adapters is indicated by the click of the latches on the frame
of the bouncer . Place the bouncer onto the structure formed (fig. G), correct installation is
characterised by a click.
1.C. Assembly of the toy bow*:
Hook the toys (12) attached to the bouncer into the eyelets on the bow (13) (fig. H). Slide the
bow with the toys into the hole in the frame of the bouncer (fig. I).
1.D. Dismantling the bouncer*:
There are two levers on the back of the adapters. Press them simultaneously (fig. J) and lift the
bouncer. To fold the bouncer seat flat, unlock the latches on the inside of the adapter.. Undo
the legs of the bouncer. ATTENTION! Do not make any changes to the product with the child
inside!
2. Feeding chair:
See‫ي‬section‫.1ي‬B‫"ي‬Assembling‫ي‬the‫ي‬high‫ي‬chair"‫ي‬for‫ي‬fitting‫ي‬the‫ي‬chair‫ي‬legs.‫ي‬After‫ي‬fitting‫ي‬the‫ي‬footrest‫ي‬
instead of the bouncer, slide the seat (7) between the legs of the chair (fig. K). Set the seat at
level 1 (the highest level) and join it to the legs with two bolts 15 A. Then insert the backrest of
the chair into the notches in the upper part of the legs (fig. L I). Screw the backrest to the legs
with four bolts 15C (fig. L II). Place the supplied cushion (14) on the seat. Fasten the cushion
straps with Velcro under the seat. First insert the bow with straps (8) into the two holes on the
backrest (fig. M I) and then into the hole on the seat (make sure the parts are securely
connected) (fig. M II). Position the tray (9) so that its ends are in the grooves in the bow with
straps (fig. N 1), then push the tray down (make sure the tray and bow are connected
correctly) (fig. N 2). Place the silicone mat (11) on the tray. The chair can be placed at the table
without using the tray (fig. R). Attention! Be aware of the possibility of your child's feet
bumping off the edge of the table.
35