Safety Guidelines - Extel Klavy 3 Guía De Instalación Y De Uso

English
Power supply: 12 V~ with the supplied transformer or 12 V
supply (not provided)
50 mA in standby
Consumption:
via the keypad front panel, memorised in the event of power
Programming:
outage
Relay (max. 1.5A, 12 V - 24 V): 1 relay: NO; NC; C terminals.
Time delay control: electric lock striker or lock, automatic opener, lighting... On/
Off Control: lighting...
relay with a duration of 1-99 seconds or On/Off function
Time delay:
The transformer must always be mounted on the DIN track of a modular board
or projecting on a non-metal support using the two mounting holes. It is under-
stood that the terminal board covers must always be refitted and that connec-
tion must be made to an electrical installation in compliance with the NFC
15-100 standard for France ONL Y ONCE THE WIRING HAS ALL BEEN
COMPLETED.
Protection: The transformer is equipped with a "PTC" thermal cut-out. In the
event of damage or a short-circuit, the following steps should be taken to res-
tore transformer protection
1. Disconnect the 230V power supply (for at least 2 min.)
2. Repair as required
3. Reconnect the 230V power supply
Default master code recording
press 56 + press
press a new default master
code (4 - 8 digits)
by default = 8 x the digit 1
+ press
New default master code
is saved
Enter your relay code and press
Instructions:
for the time-out you programmed.
If the relay is programmed in the On/Off mode, enter your relay code and
press , to switch it off, re-enter your code and press #
CHARACTERISTICS

SAFETY GUIDELINES

with a DC power
Recording relay code
press 51 + press
press a new relay code
(4 - 8 digits)
by default = 12345678
+ press
New relay code
is saved
, the relay will be operational
# .