Programming Mode - Extel Klavy 3 Guía De Instalación Y De Uso

PROGRAMMING MODE

Connect the 12 V ~ or 12 V
Enter the default master code = (8 x
the digit 1) + press
The red LED lights up
Relay time-out
press 52 + press
press the relay time-out
(2 digits between 01 and 99)
e.g. : 05 = 5 seconds
00 = on/off
by default = 5 seconds
+ press
Time-out
is saved
Press this key
RESET:
off the power supply immediately. Switch the power supply back on, release
after 6 beeps.
Start up the system
(and hold down during the entire procedure). Switch
= Melody
DEFAULT MODE
power supply
Enter the default relay code =
(12345678) + press
The door is open
(The green LED lights up)
The keyboard beeps 4 times = error
Reconfigure by default
press 50 + press
The system is reconfigured
by default
Relay code ≠ Master code
or