Tripp-Lite P131-06N-2VA-U Manual Del Propietário página 4

Installation
Note:
• The video port on the same side of the unit as the USB
Micro-B port is the only port that will transmit EDID
information to the connected source. Connect this port to
the monitor that has the EDID information you wish to use.
1. Make sure the power to all devices you are
connecting is turned off prior to installation.
2. Connect the built-in latching HDMI cable to the
source video output port.
3. Connect the included USB Micro-B cable between
the unit and a USB port on the source or a USB
wall outlet.
4. Connect the monitor that has the EDID information
you wish to use to the video output port on the
same side of the unit as the USB Micro-B port
using a VGA cable, such as Tripp Lite's P504-
Series VGA + Audio Cable.
5. Connect the 3.5 mm audio port to the audio jack
on your monitor or speakers.
6. Connect a second monitor to the remaining video
output port using a VGA cable, such as Tripp Lite's
P504-Series VGA + Audio Cable.
7. Connect the second 3.5 mm audio port to the
audio jack on your monitor or speakers.
8. Turn on the power to the source and displays. The
orange LEDs next to each video output port will
illuminate to indicate the unit is powered on and
transmitting a signal to the connected monitors.
18-01-069-9337CB.indb 4
All manuals and user guides at all-guides.com
4
1/26/2018 10:23:41 AM