Connecting A Pc Or Macintosh - Plus U2-1130 Manual Del Usuario

C o n n e c t i n g
Connecting a PC or Macintosh to the unit will enable you to project your computer screen images for impressive presentations.
• The following display standards are supported:
VGA 640×480 for graphics
VGA 640×350 for graphics
VGA 720×350 for text
VGA 640×400 for graphics
VGA 720×400 for text
• U2-1130 A PC, Macintosh, or computer equipped with an XGA adapter or compatible graphics adapter can easily be connected.
U2-1110
(U2-811) A PC, Macintosh, or computer equipped with an S-VGA adapter or compatible graphics adapter can easily be connected.
• U2-1130 If your PC does not support XGA you will need to install an XGA graphics board. Consult your computer's owner's manual for
U2-1110 your XGA configuration. If you need to install a new board, refer to the manual supplied with your new graphics board for
installation instructions.
(U2-811) If your PC does not support S-VGA/VGA you will need to install an S-VGA/VGA graphics board. Consult your computer's
owner's manual for your S-VGA configuration. If you need to install a new board, refer to the manual supplied with your new
graphics board for installation instructions.
Notes
• Refer to the owner's manual supplied with your computer for more information about the video output requirements of the computer and any special
identification or configuring required by the projector image and monitor.
Some Macintosh PowerBooks may need to set the mirroring to off to output 1024 × 768 dot signals. Please consult your PowerBook
• U2-1130
U2-1110 manual or computer dealer for details.
(U2-811) Some Macintosh PowerBooks may need to set the mirroring to off to output 800×600 dot signals. Please consult your PowerBook
manual or computer dealer for details.
Before connecting
• Turn off the computer that is to be connected.
• The unit and computer will be turned on in "Using the unit" on page 15. Do not turn on either the computer or the unit until you read this
section.
• Please also refer to the manual of the computer to be connected.
IBM PC/AT compatible machine or
Macintosh with Mini D-Sub 15-pin
connector
Mini D-Sub
15-pin
connector
PC/Macintosh multicable
(supplied)
Plug the cable connector
into the RGB IN connector
securely and tighten the
screws.
All manuals and user guides at all-guides.com
a P C o r
SuperVGA 800×600
XGA 1024×768 (U2-1130/U2-1110 only)
Macintosh at 640×480
Macintosh at 832×624
Macintosh at 1024×768 (U2-1130/U2-1110 only)
Macintosh desktop computer
To PC's audio jack
Monitor adapter for
Macintosh
You may need to
change the DIP switch
setting depending on
the machine to be
connected. See next
page.
Mini D-Sub
15-pin
connector
MOUSE RGB IN
E – 12
M a c i n t o s h
To Macintosh's audio jack
Mini D-Sub 15-pin connector
PC audio cable
(supplied)*
PC/Macintosh multicable
(supplied)
* When VIDEO or S-VIDEO is selected as the input source,
the sound from the AUDIO L/MONO /R jacks will be
output.
When RGB is selected as the input source, the sound from
the PC AUDIO jack will be output.
The unit's
PC AUDIO S-VIDEO VIDEO AUDIO
L/MONO R
terminal panel