Mx Onda MX-HE2663 Manual De Usuario E Instalacion página 47

Removing and installing the oven door
The oven door can be removed to facilitate cleaning, to do this, follow the steps
below:
1. Fully open the oven door 90º, then unlock it by pulling the hinge lock up
with the help of a screwdriver as shown in Figure 8.1.
2. Set the hinge lock at the largest angle as shown in Figure 8.2. Adjust the
two hinges that hold the door to the oven to the same position.
3. Then close the door so that it is in contact with the hinge lock, as shown in
Figure 9.1.
4. In order to easily remove the oven door, when it approaches the closed
position, grasp the door with both hands and pull it upwards, see Figure
9.2.
Fig. 7
Fig. 8.1
Cleaning the oven door glass
To remove the glass from the oven door and depending on the model you
have, you must proceed as indicated in point 1 or point 2.
1. Press the plastic latches located on both sides (right and left) of the profile
as shown in Figure 10, then remove the profile by pulling it out as shown in
Fig. 8.2
22
Fig. 9
Fig. 9.1 Fig. 9.2