Mx Onda MX-HE2663 Manual De Usuario E Instalacion página 49

Once the bulb has been replaced, replace the glass protection and re-establish
the power supply to the oven (plug or magnetothermic switch).
G9 Lamp type
Support guides
Warning: It is very important to correctly position the support guides. Do not
place the guides touching the back of the oven. The position of the support
guides for is shown in the following figure.
Rack 4
Rack 3
Rack 2
Rack 1
Removing and inserting the support guides
Press the clips in the direction indicated by the arrows and separate the bottom
of the support guides from the oven wall, then slide the support guides up and
remove them.
To insert the support guides, pay attention to their position (see the previous
figure), insert the hooks located at the top of the support guides into the holes
located on the wall of the oven, then slide the support guides downwards and
slightly press the clips (in the direction of the arrows) secure them to the lower
bracket.
E14 Lamp type
Fig. 16
24
Fig. 17