Mx Onda MX-HE2657 Manual De Usuario E Instalacion página 29

INSTALLATION
Warning: Before installing the oven, check that there is no damage to the
oven. DO NOT install the oven if after removing the packaging you notice
damage to it, bumps, broken or cracked glass, damaged cord or plug, etc.
Very important: The cooling fan extracts heat to
prevent overheating of external surfaces during
oven operation. The fan is essential to improve
the cooking and performance of the appliance.
The cooling fan will continue to run after cooking
is complete and will stop automatically when the
outside oven temperature is low.
You must leave a space behind the back of the oven and never obstruct the air
inlet holes (located at the bottom of the sides) for optimal and efficient cooling
(Figure 1). Good oven cooling is essential for optimal and long-lasting
operation.
Oven location
This oven is designed to be installed in furniture openings of 60 cm, you must
install it leaving a space or safety distance between the walls of the oven and
the walls of the cabinet, refer to the illustrations on the following pages to
obtain the correct measurements (the values are in millimeters).
•
The surfaces used, synthetic sheets, adhesives, etc. They must be heat
resistant (minimum 100 ºC).
•
The kitchen cabinet where the oven is located must be level and fixed to
the rest of the furniture.
•
If there is a drawer under the oven, you must place a protection grid
between them.
Warning: Do not install the oven next to the refrigerator or refrigerator. The
heat emitted by the oven increases the energy consumption of the refrigeration
appliances.
Warning: Do not use the door or door handle to carry or carry the oven.
8
Fig. 1