Technical Data; Preparations At The Workplace - Hilti NPU 100-22 Manual De Instrucciones Original

Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
3.5 Items supplied
Knockout punch, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

Rated voltage
Weight without battery
max. punching capacity
Storage temperature
Ambient temperature for operation
4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
*2321734*
Meaning
The battery can remain in use.
The check to ascertain the battery's state of health
did not complete. Repeat the procedure, or consult
Hilti Service.
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
2321734
NPU 100-22
21.6 V
5.1 lb
(2.3 kg)
10 ga Steel 4.0 in
(102 mm)
10 ga Stainless 4.0 in
steel
(102 mm)
−4 ℉ ... 158 ℉
(−20 ℃ ... 70 ℃)
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
21.6 V
See the end of these
operating instructions
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
−4 ℉ ... 104 ℉
(−20 ℃ ... 40 ℃)
14 ℉ ... 113 ℉
(−10 ℃ ... 45 ℃)
English 7