Power Connection; Alarm Time Setting - Denver CR-418 Instrucciones De Uso

All manuals and user guides at all-guides.com

POWER CONNECTION

Plug the AC power cord to a household outlet AC source. This unit
is equipped with a battery back up system, it requires a 3V CR2032
flat lithium battery (not included). Insert the battery in the battery
compartment, making certain that the positive and negative (+ and -)
battery terminals are attached to the corresponding terminals on the
plate in the battery compartment. If an AC power failure occurs, the
clock automatically switches to the battery power supply, the clock and
timer memory continue running. When the AC power resumes, the
clock switches back to AC again.
TIME MANUAL SETTING
In standby mode, press and hold the SET.MEM / M+ button (9), "24
Hr" will blink. Press the Tune + (8) or Tune – (4) button to set the hour
format between 12 hour (12 Hr) format and 24 Hour (24 Hr) format.
Press the SET.MEM / M + button (9) and the hours will blink.
Press the Tune+ (8) or Tune – (4) to set the current hour.
Press the SET.MEM / M + (9) button again then the minute digits will
blink. Press the Tune + (8) or Tune – (4) to set the current minutes.
Once setting done, press SET.MEM / M + (9) button once again to
indicate the current time is set.

ALARM TIME SETTING

1. To preview the alarm time. Press the ALARM button (2/3) once.
2. While the display is showing the alarm time and you hold the
ALARM button for 3 seconds and the hours will blink.
3. Press the Tune + (8) or Tune - (4) to set the alarm hour.
4. Press the ALARM button again; the minute digits will blink. Press
the Tune + (8) or Tune – (4) to set the alarm minutes.
5. Press the ALARM button and you can change the sound mode
(Buzzer, Radio) for the alarm.
6. Press Tune + (8) or Tune – (4) to choose different volume. The
alarm volume will gradually increase. Then press the ALARM
button when done.
7. To delay the alarm, press SNOOZE. It will come on again in
approx. 9 minutes. You may repeat this cycle several times during
the alarm cycle. To stop the alarm, press ALARM button.
8. To stop the alarm from coming on the following day, hold the