Power Supply - Denver CR-425 Manual De Instrucciones

POWER SUPPLY

The unit can be powered by either AC power or batteries.
Manufacturer's name or trade mark,
commercial registration number
and address
Model identifier
Input voltage
Input AC frequency
Output voltage
Output current
Output power
Average active efficiency
Efficiency at low load (10%)
No-load power consumption
OPERATING THE UNIT ON AC POWER
Insert one end of the supplied power cord to the DC jack at the rear of the unit, and the
other end into the wall outlet.
When connecting the power cord, make sure that the power cord is firmly pushed into the
DC jack and the wall outlet for power supply.
OPERATING THE UNIT ON BATTERIES
1. To operate the unit on batteries, the AC power cord must be disconnected from the unit.
2. Unplug the AC power cord from the unit and insert 3 AA batteries (not included) in the
battery compartment.
3. Close the battery compartment door.
1.5V AA
Batteries
Note: Check your batteries regularly. Old or depleted batteries should be replaced. If the
unit is not to be used for some time, or is being run exclusively on AC power, remove the
batteries from the battery compartment to avoid battery leakage.
DongGuan Obelieve Electronic Co.,Ltd
91441900050747698U
Huazhaoxin Industrial Park B-4/F,
Golden Phoenix Industrial Zone,
FengGan Town, DongGuan,
GuangDong Province,P.R.C.
0BL-0501000B / OBL0501000E
100-240V
50/60HZ
5.0V
1.0A
5.0W
76.52%
--
0.081W
ENG-4