SEVERIN SEPURO HV 7184 Instrucciones De Uso página 16

Recommended suction mode:
ECO : for slightly soiled hard floors, curtains, drapes and the like
MIDDLE : for slightly soiled carpets, heavily soiled hard floors
POWER : for carpets, rugs, upholstery, mattresses and car seats
TURBO mode : for heavily soiled floor coverings or upholstery
Approximate running time in power modes
With a fully charged battery, the running time is as follows:
ECO : approx. 60 minutes
MIDDLE : approx. 30 minutes
POWER : approx. 12 minutes
TURBO mode : the appliance switches to POWER mode in 2 minutes
Dust level indicator
∙ The appliance is equipped with a dust level indicator. Make sure you change the dust bag or empty the dust container
when the LED above the display
∙ The LED flashes when the dust bag needs to be changed promptly or the dust container needs to be emptied promptly.
∙ When the LED glows red steadily, the appliance is rendered inoperable and requires prompt change of the dust bag or
emptying of the dust container.
For appliances without dust bags
Emptying the dust container
∙ The dust container can only hold a limited quantity of dirt.
∙ It is therefore highly recommended that you empty the dust container after every cleaning und when the suction power
drops noticeably or when the dust level indicator lights up red:
1. Make sure that the appliance is switched off.
2. Remove the tool and the suction tube.
3. Push the locking latch on the bottom of the dust container. Open the flap of the dust container and empty the dust
container.
4. Close the flap of the dust container.
Cleaning the dust container
∙ You can easily clean the dust container with filter:
1. Make sure that the appliance is switched off.
2. Remove the tool and the suction tube.
3. Press the
4. Push the locking latch on the bottom of the dust container. Open the flap of the dust container and empty the dust
container. (see Fig. III)
5. Fold the handle (semicircle) back on the dust container filter and remove the filter.
6. Loosen the filter insert with metal sieve by turning it and then remove it.
7. Pull out the foam filter and brush it off carefully if necessary.
8. All filter parts should be rinsed with lukewarm water and allowed to dry for 24 hours.
9. The dust container should be rinsed with lukewarm water and allowed to dry for 24 hours with the lid open.
10. We recommend that you dry the parts on a radiator. Make sure that the parts are completely dry before reassembling
them.
11. Replace the dry foam filter, attach the filter insert with metal sieve and turn to lock in place.
12. Slide the filter back into the dust container. The locking tab on the filter must fit into the dust container recess.
16
Maintaining the appliance
on the handle lights up red.
button on the top of the appliance and remove the dust container by pulling it downwards.