Italtecnica Sirio Universal Manual De Programación página 15

ADVANCED PARAMETERS:
The advanced parameters are accessible only to the technical assistance service. For access to these parameters, it is necessary to contact the
re-seller, a technical assistance centre or the manufacturer.
The following table lists the advanced parameters for reference when technical assistance is required.
REF. PARAMETER
3.0 Pressure calibration 0.0 Bar
3.1 Pressure calibration 5.0 Bar
3.2 Flow sensor calibration
3.3 Pressure test
3.4 Flow switch test
3.5 Software Release
3.6 Power supply timing
3.7 Pump timing
3.8 Last error
3.9 Start-up
4.0 Vboost
4.1 Dry run
4.2 Protection starts per hour
4.3 Anti-blockage protection
4.4 Dead time PWM
4.5 Ki
4.6 Kp
4.7 Boost time
5.0 Ta max
5.1 Tm max
5.2 Ta reduction index
5.3 Tm reduction index
5.6 Minimum voltage
5.7 Maximum voltage
5.9 Debug Variable
DESCRIPTION
To carry out calibration of the pressure sensor at 0 Bar
To carry out calibration of the pressure sensor at 5 Bar
To carry out calibration of the flow sensor
Current pressure test signal
Flow switch test signal
Release of software
Inverter power supply timer
Electric pump operational timer
Last error occurred log
Pump start-up counter
Voltage boost at 0Hz
Time delay before activation of the protection due to no water
Activation or deactivation of the control on the number of start-ups per hour (leak
checks)
Activation or deactivation of a function that automatically starts up the pump after 24
hours of disuse
Dead time PWM setting
PID controller integral constant
PID controller proportional constant
Boost time at maximum frequency with soft start disabled
Maximum ambient temperature
IGBT module maximum temperature
Frequency reduction index on ambient temperature
Frequency reduction index on module temperature
Minimum power supply voltage threshold
Maximum power supply voltage threshold
Debug variable selection for process value display