Releasing And Inserting The Battery Pack; Charging The Battery Pack - Bosch PB360C Instrucciones De Funcionamiento

BM 2610032718 07-15.qxp_BM 2610027750 01-13.qxp 7/17/15 10:38 AM Page 10
Releasing and Inserting
To release or insert the battery pack from radio unit, open
the charger door by unlocking the latch. To insert battery,
align battery with terminals and slide battery pack onto
terminal until it locks into position. Do not force.
To release battery, depress battery release button and slide
battery of the terminals.
Charging Battery Pack
CHARGER OPERATION:
Insert battery and close door.
Charge only Bosch batteries (
BAT620)
WARNING
causing injury and damage. Read additional safety
information on underside of radio.
Battery Pack
DOOR RELEASE
LATCH
. Other batteries may burst
Open charger door by releasing latch. Plug the unit's power
cord into your standard power outlet, then insert battery pack
into charger.
1. The LCD will display the "CHARGING
front of the unit. This indicates the battery pack is
charging.
2. When the word "CHARGING" next to the battery ICON
disappears, charging is complete.
3. The purpose of the charging icon on the LCD is to indicate
that the battery pack is charging. The charging icons will
disappear in less time if the battery pack was not
completely discharged.
4. When the battery pack is fully charged, the battery pack
can be inserted into a tool, or used to power the radio
instead of the power cord.
Note: It is recommended that the battery charger bay door
be kept shut at all times.
BAT600 -
10
" ICON on the
TERMINALS
REPLACE AA BATTERY
WHEN UNIT NO LONGER
KEEPS CORRECT TIME