Operating The Appliance - Morphy Richards 47507 Manual Del Usuario

47507MEE Rev 2 14/12/06
OPERATING THE
APPLIANCE
Filling the water
reservoir
Remove to fill the water reservoir, C
1
slide the water tank upwards using
the handle. Open the lid of the
water reservoir ⁄ by pulling up and
sliding backwards.
IMPORTANT: Do not overfill or carry
with the handle when full.
Fill the water reservoir ⁄ using cold
2
tap water, 1.7 litres maximum D.
3 Replace the water reservoir by
sliding it back into place E.
Using with ground
coffee
Ensure the coffee/steam lever Î is
in the off position.
1 Plug the unit into the power outlet.
2 Switch the unit on by pressing the
on/off switch ›. The blue 'power
light' ¤ and the display Ï will
illuminate.
3 Pre-heat your coffee cups by
placing them upside down on the
warming plate Ì.
Note: This machine is designed for
use with espresso or cappucino
cups only. The coffee will emerge
much weaker if larger cups are
used.
Select the required filter „ for 1
4
cup or ‰ for 2 cups and place in
the filter holder ‡ F.
5 Using your measuring spoon Ê
supplied, place one or two
measures of ground coffee into the
filter, depending on filter choice.
With the other end of the measuring
spoon, use the tamper Á to tamp
down the coffee G.
IMPORTANT: Be sure not to overfill
the filter with too much coffee, and
wipe around the edge of the filter to
remove any coffee grounds.
Place the filter holder ‡ on the
6
brewing head fi and position the
handle so it points to the left H.
16:33 Page 5
All manuals and user guides at all-guides.com
• Ensure the filter holder is flat against
the brewing head and turn the
handle towards the right I as far as
it will go.
7 Place 1 or 2 pre-heated cups below
the outlet holes of the filter holder J
and K. When the coffee maker is at
the correct temperature the
sign will be displayed.
8 Move the lever down to the coffee
setting. You will hear the machine
make a pumping noise, this is
normal.
9 Once the cups are filled to the
desired level, move the lever to the
off position. Water will still filter
through for approximately 8
seconds after the lever has been
moved to the off position.
10 Carefully remove the filter holder
by turning the handle slowly to
the left.
11 To remove the used coffee grounds
from the filter, push the filter lock fl
forward over the edge of the filter
and turn the filter holder upside
down. Gently tap out the coffee L.
12 Once the
machine is ready to make the next
espresso.
Note: It is normal for the symbols
on the display to cycle on and off
during the water heat up process.
Using with coffee
pods
Note: This coffee machine can use
both 'soft and 'hard' coffee pods.
When using 'hard' coffee pods use
the special pod filter holder Â.
When using 'soft' coffee pods use
the 1 cup filter holder „.
Select the required filter  for
1
'hard' pod or „ for 'soft' pod and
place in the filter holder M.
2 Remove the espresso pod from the
packaging N.
3 Place the coffee pod in the filter ‡.
Ensure that the flap is placed inside
the filter O.
www.morphyrichards.com
sign shows, your
g
5