Fluidmaster THE EVERYTHING Guía De Instalación Rápida página 3

STEP 2: REMOVE OLD PARTS
A: REMOVE CONNECTOR
Remove water supply
connector from bottom of fill valve.
NOTE: Inspect water
supply connector. Replace it if
it is worn, or you don't know
how old it is, to prevent flooding
Towel
and property damage.
(Optional)
B: REMOVE OLD LOCKNUT
Use green tool to twist locknut below
tank to remove locknut from fill valve.
Green Tool
C: REMOVE OLD FILL VALVE
Including refill tube, refill clip and
shank washer. Drain any excess
water into the back panel of
empty packaging by removing fill
valve from tank. (Pull fill valve up)
D: DISCONNECT
FLAPPER CHAIN
4
All manuals and user guides at all-guides.com
E: REMOVE TANK FROM BOWL
F: LAY TANK ON ITS SIDE
G: REMOVE GASKET
H: REMOVE FLUSH VALVE
Tank Lever
Use green tool to unscrew nuts from
under the bowl and remove bolts
from tank.
NOTE: Bolts can be
loosened from inside tank.
Green Tool Screwdriver
(Optional)
Place on a safe and secure surface.
Remove tank-to-bowl gasket from
below the tank.
LOCKNUT
red wrench, twist locknut
Using
to remove. Remove old flush valve
from tank.
Red Wrench
5