Fluidmaster THE EVERYTHING Guía De Instalación Rápida página 9

STEP 10: FINE-TUNE TANK WATER LEVEL
A: FLUSH THE TOILET TO
CHECK THE TANK WATER
LEVEL
After the water stops filling the
tank, the water level should be
roughly ½ inch below the top
of overflow pipe to ensure a
proper flush.
B: WATER LEVEL IS TOO LOW
Turn the tank water level adjustment screw clockwise to
raise the float. Flush to reset water level.
WATER LEVEL IS TOO HIGH
Turn the water level adjustment screw counterclockwise to
lower the float. Flush to reset water level.
–
16
All manuals and user guides at all-guides.com
1/2"
Overflow
Pipe
See Step 7A for Full Tank view.
Tank Water Level
Adjustment Screw
+
STEP 11: FINE-TUNE FLUSH
A: TEST FLUSH
Drop 3 squares of toilet paper in
bowl then flush.
B: ADJUST FOR MOST EFFICIENT FLUSH
Continue to adjust dial down one setting and flush until toilet
is unable to flush paper properly.
Note: Turn off water. Remove flapper for easy adjustment (see Step 6).
LESS
WATER
FLUSHED
C: FINAL SETTING
Once unable to flush, adjust dial up one for final setting.
MORE
WATER
FLUSHED
Hint: The higher the number,
the longer the flapper stays
open for more water flushed.
17