Trunk Support; Entry And Exit; Adjusting The Angle Of The Handle; Adjusting The Length Of The Handle - Vela Miniwalk Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.0.9. TRUNK SUPPORT

The trunk support is opened by moving the outer handles (on
the back) upwards. The trunk support is closed by sliding the
handles down again so that the opening is smaller. Note: The
trunk support must always be closed when the gait trainer is in
use.

2.0.10. ENTRY AND EXIT

Grab the front of the tilt bar* with both hands and tilt it. This
lowers the seat unit, which facilitates entry and exit. The seat
unit is raised again by pressing down the tilt bar until it locks
in the click hook with an audible click. Note: Close the trunk
support (see section 2.0.9.) and rear stop (section 2.0.13.) when
the gait trainer is in use.

2.0.11. ADJUSTING THE ANGLE OF THE HANDLE

Loosen the Allen screw in the two cones on which the
handle is mounted. Adjust the handle to the desired angle and
retighten the Allen screws in the two cones.
Note: The handle can be angled in a vertical position, so the
user has free access to e.g., a worktable and kitchen table.

2.0.12. ADJUSTING THE LENGTH OF THE HANDLE

Loosen the two screws under the cones on which the handle
is mounted. The handle can now be adjusted forwards or
backwards. Adjust the handle to the wanted position and
retighten the screws.
*Never let go of the tilt bar when raising or lowering it.
1 4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

106061106062

Tabla de contenido