User Manual; Assembly Of Upper Part And Base; Assembly And Replacement Of Springs; Brake - Vela Miniwalk Instrucciones De Uso

2.0. USER MANUAL

2.0.1. ASSEMBLY OF UPPER PART AND BASE

The upper part is placed in the risers on the chassis. The upper
part is lowered into place in the two risers.
Note: The handle must face the swivel front wheels.

2.0.2. ASSEMBLY AND REPLACEMENT OF SPRINGS

The first time the gait trainer is assembled, the supplied springs
must be fitted. Unscrew the Allen screws in the telescopic tube
(Allen key is located in the rear stop). Remove the plug at the
bottom. Attach the springs to the plugs, push the plugs into the
telescopic tube and refit the screws.

2.0.3. BRAKE

The brake rods are located in front of the rear wheels. Move
both brake rods backwards to activate the brake function on
both sides. The brakes are deactivated by moving both brake
rods forward again. Note: The brake must always be locked
when getting in and out of the gait trainer.

2.0.4. BRAKE ADJUSTMENT

Move the brake rods forward and loosen the two nuts that
attach the brake to the chassis. The brake mechanism can then
be adjusted back and forth. There must be 3-5 mm clearance
between the brake fitting and the cover. Remember to tighten
the nuts again. Note: do not adjust the brakes while the gait
trainer is in use.
1 2