Vivotek SD8363E Guía De Instalación Rápida página 7

2. Feed the Ethernet cable and IO wires through the mounting bracket, the openings on
the dome cap, and to the interface section. Attach the rubber seal plug to dome cap for
water proofing.
3. Secure the included ground wire to the dome cap, pass it through the mount bracket,
and connect the other end to a grounded conduit later.
4. Remove seal from the breathe hole on the top section if your camera comes with the
dehumidifier.
Mount bracket
Dome cap
Interface Section
NOTE:
1. IO wires are user-supplied.
2. Avoid touching the circuit boards to prevent damage by electro static discharge.
All manuals and user guides at all-guides.com
2
3
EN-6
4