Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SENSOR (Continued):
Settings
•
Detection area, hold time, and daylight sensor can be set by using DIP switches on the sensor. Note that
reducing the detection area will also reduce the sensitivity.
Detection Area
1
2
100%
ON
ON
75%
ON
-
50%
-
ON
25%
-
-
Hold Time
•
Refers to the time period the lamp remains at
100% illumination after no motion is detected.
3
4
5S
ON
ON
30S
ON
-
1 Min
-
ON
5 Min
ON
-
10 Min
-
ON
15 Min
-
-
30 Min
-
-
Stand-by Dim Level
•
This is the pre-set dimming level you would
like to have after the hold time in the long
absence of people.
1
2
10%
ON
ON
20%
ON
-
30%
-
ON
50%
-
-
EiKO Global, LLC • 23220 W. 84th St, Shawnee, KS 66227 • (P) 1-800-852-2217 • (F) 1-800-492-8975 • eiko.com
EiKO Canada • 81 King St, Barrie, Ontario L4N 6B5 • (P) 1-705-721-5189 • (F) 1-705-721-7855 • orderdesk@eiko.com
5
ON
ON
ON
-
-
ON
-
Stand-by Period
•
Refers to the time period the lamp remains at
a pre-set dimming level before it completely
switches off in the long absense of people.
6
7
0S
ON
ON
1 Min
ON
-
3 Min
-
ON
5 Min
ON
-
10 Min
-
ON
30 Min
-
-
+∞
-
-
Daylight Sensor
•
The sensor can be set to only allow the lamp to
illuminate below a defined ambient brightness
threshold.
•
When set to Disable, the daylight sensor will switch
on the lamp when motion is detected regardless of
ambient light levels.
•
It should be set to Disable mode if the motion
sensor is connected to stand-alone daylight
sensors.
3
5 Lux
ON
15 Lux
-
30 Lux
ON
50 Lux
-
100 Lux
ON
150 Lux
ON
Disable
-
8
ON
ON
ON
-
-
ON
-
4
5
6
ON
ON
ON
ON
ON
ON
-
ON
ON
-
ON
ON
ON
-
ON
ON
ON
-
-
-
-
Publicidad
Tabla de contenido
