6 6 6 6 6
electr
electr
olux
olux
electr
electr
electrolux
olux
olux safety warnings
For the installer
For the installer
For the installer
For the installer
For the installer
• When used as an extractor unit, the
GB
hood must be fitted with a hose
having preferably the same diameter
as the outlet hole.
Attention: The hose is not supplied
Attention:
Attention:
Attention:
Attention:
and must be purchased separately.
• • • • • When installing the hood, make sur
When installing the hood, make sure e e e e
When installing the hood, make sur
When installing the hood, make sur
When installing the hood, make sur
you observe the following minimum
you observe the following minimum
you observe the following minimum
you observe the following minimum
you observe the following minimum
distance fr
distance from the top edge of the
distance fr
distance fr
distance fr
cooking hob/ring surfaces:
cooking hob/ring surfaces:
cooking hob/ring surfaces:
cooking hob/ring surfaces:
cooking hob/ring surfaces:
electric cookers
electric cookers
electric cookers
electric cookers
electric cookers
gas cookers
gas cookers
gas cookers
gas cookers
gas cookers
If the instructions for installation for
the gas hob specify a greater
distance, this must be adhered to.
• The national Standard on fuel-
burning systems specifies a maxi-
mum depression of 0.04 mbar in
such rooms.
• The air outlet must not be connected
to chimney flues or combustion gas
ducts. The air outlet must under no
circumstances be connected to
ventilation ducts for rooms in which
fuel-burning appliances are installed.
• The air outlet installation must comply
with the regulations laid down by the
relevant local authorities.
• When the unit is used in extraction
mode, a sufficiently large ventilation
hole must be provided, with
dimensions that are approximately
the same as the outlet hole.
• National and regional building
regulations impose a number of
restrictions on using hoods and fuel-
burning appliances connected to a
chimney, such as coal or oil room-
heaters and gas fires, in the same
room.
om the top edge of the
om the top edge of the
om the top edge of the
om the top edge of the
500 mm
500 mm
500 mm
500 mm
500 mm
650 mm
650 mm
650 mm
650 mm
650 mm
• Hoods can only be used safely with
appliances connected to a chimney if
the room and/or flat (air/environment
combination) is ventilated from
outside using a suitable ventilation
hole approximately 500-600 cm
large to avoid the possibility of a
depression being created during
operation of the hood.
• If you have any doubts, contact the
relevant controlling authority or
building inspector's office.
• Since the rule for rooms with fuel
burning appliances is "outlet hole of
the same size as the ventilation hole",
a hole of 500-600 cm
say a larger hole, could reduce the
performance of the extractor hood.
• If the hood is used in its recirculation
mode, it will operate simply and safely
in the above conditions without the
need for any of the aforementioned
measures.
• When the hood is used in its
extraction mode, the following rules
must be followed to obtain optimal
operation:
- short and straight outlet hose
- keep bends in outlet hose to a
minimum
- never install the hoses with an
acute angle, they must always
follow a gentle curve.
- keep the hose as large as possible
(preferably the same diameter as
the outlet hole).
- the length should be no more than:
3 metres with one 90° bend
2 metres with two 90° bends
Bends of more than 90° will reduce
the efficiency of the hood and
reduce the airflow.
• Failure to observe these basic
instructions will drastically reduce the
performance and increase the noise
levels of the extractor hood.
2
2
, which is to