Electrolux EFG 50354 Manual De Instrucciones página 8

1
Functioning of the contr Functioning of the contr
Functioning of the control panel Functioning of the contr Functioning of the contr
1 1 1 1 1 Key OFF motor
2 2 2 2 2 Speed selection key (power) 1 1 1 1 1
3 3 3 3 3 Speed selection key (power) 2 2 2 2 2
4 4 4 4 4 Speed selection key (power) 3 3 3 3 3
5 5 5 5 5 Intensive speed selection key
(power), this lasts 5 minutes, after
which the extractor motor switches
off or the hood goes back to the
suction speed (power) previously
selected. In order to deselect this
suction speed, press buttons 1 1 1 1 1 or 2 2 2 2 2
or 3 3 3 3 3 or 4. 4. 4. 4. 4.
6 6 6 6 6 ON/OFF lights key
7 7 7 7 7 Settings and reset signals of filter
saturation: this key lights up in order
to warn you of the fact that the
maintenance of the grease filter must
be carried out while it is blinking, in
order to warn you that the
maintenance of the carbon filter must
be carried out.
After cleaning or replacing the filters,
press button 7 7 7 7 7 for 3 seconds until the
grease/charcoal filter key 7 7 7 7 7 stops
flashing.
2 3 4
ol panel ol panel
ol panel ol panel
electrolux electrolux electrolux electrolux electrolux control panel
5
Settings for the saturation signals of Settings for the saturation signals of
Settings for the saturation signals of Settings for the saturation signals of Settings for the saturation signals of
the gr the gr the gr the gr the grease filters and active carbons: ease filters and active carbons: ease filters and active carbons: ease filters and active carbons: ease filters and active carbons:
The saturation signalling device of the The saturation signalling device of the
The saturation signalling device of the The saturation signalling device of the The saturation signalling device of the
active carbon filters is disactivated. active carbon filters is disactivated. active carbon filters is disactivated. active carbon filters is disactivated. active carbon filters is disactivated.
In case you want to install a filter to the
active carbons, at the end press key 1 1 1 1 1
(motor off), then press AND HOLD
DOWN DOWN DOWN DOWN DOWN key 7 7 7 7 7 , after which ALSO
key 5, 5, 5, 5, 5, a beep and key 7 7 7 7 7 lights up in
order to indicate that the controlling
device for the carbon saturation filter is
activated.
Repeat the procedure in order to
disactivate the activated carbon
saturation filter signalling device.
V V V V V erification of the status of the erification of the status of the erification of the status of the
erification of the status of the erification of the status of the
saturation signalling of the carbon saturation signalling of the carbon saturation signalling of the carbon saturation signalling of the carbon saturation signalling of the carbon
activated filters: activated filters: activated filters: activated filters: activated filters:
Briefly press key 7, 7, 7, 7, 7, if this lights up for a
few seconds the activated carbon
saturation filter signalling device is
activated, if key 7 7 7 7 7 does not light up the
activated carbon saturation filter
signalling device is not activated.
6 7
AND HOLD AND HOLD
AND HOLD AND HOLD
ALSO ALSO ALSO press ALSO
9 9 9 9 9
GB