Description Of The Appliance; Use; Cleaning The Interior; Starting-Up - Kuppersbusch IK 164-4 Z Istrucciones Para El Montaje Y El Uso

DESCRIPTION OF THE APPLIANCE

Butter shelf
Shelves
Bottle shelf
Salad drawer
Storage shelves
Thermostat

USE

Cleaning the interior

Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.

Starting-up

Insert the plug into the wall socket.
Open the door and turn the thermostat control knob,
to be found on the upper right hand side of the inner
compartment, clockwise beyond position «O» (OFF)
to start the appliance.

Temperature control

Temperature adjustment is obtained by turning the
thermostat knob clockwise until its pointer coincides
with the required setting.
A medium setting is generally the most suitable.
The minimum setting (least cold) is represented by
the lowest number and the maximum setting
(coldest) by the highest number. In any case, bear in
mind that the temperature can be either increased
(warmer) by turning the thermostat knob
anticlockwise or decreased (colder) by turning it
clockwise.
The thermostat knob setting should be adjusted
depending on the inner temperature of the
refrigerator, which, in turn, depends on a number of
factors, such as: the ambient temperature, the
number of times the door is opened, the quantity of
food stored and the location of the appliance.
Warning
If the ambient temperature is high, the
thermostat knob is on the coldest setting
(higher numbers) and the appliance is fully
loaded, the compressor may run
continuously, causing frost or ice to form on
the evaporator. If this happens, turn the knob
to a warmer setting (lower numbers) to allow
automatic defrosting and so a saving in
electricity consumption.
15