Festo 8131016 Instrucciones De Utilizacion página 21

Operating Robotino 4 with a laser sensor
When operating the Robotino 4 with a laser sensor, install the two reflectors.
Proceed as follows:
1. Undo the three screws that connect the cover of the charging station to the housing. Make sure that no
small parts fall into the device during installation.
2. Do not remove the cover completely, as the marker cable is plugged in.
3. Detach the M8 plug on the left on the inside of the housing and pull both cable and plug through the
opening in the cover.
4. Seal the opening in the cover using the enclosed plastic cap.
5. Fasten all the screws back in place.
6. Mount the two reflectors on the charging station (one on each side) using the enclosed screws.
7. Plug the power supply cable back into the charging station's IEC plug.
8. Switch the charging station on.
Figure 8: Charging station with reflectors
© Festo Didactic 8134684
Robotino 4 Charging Station – Operating instructions
21