Intended Use; Package Contents - LIVARNO LUX LSLB 100 A1 Manual De Instrucciones E Indicaciones De Seguridad

LIVARNO LUX LSLB 100 A1

1. Intended use

This LED emitter is not intended for commercial use. It is only suitable for outdoor use. The LED emitter is a
specialist product which is designed to withstand extremely low temperatures of below minus 21 °C. The
LED emitter is not designed to provide room lighting within the home. This LED emitter is not intended for
use in tough conditions.
The device fulfils all relevant norms and standards relating to CE conformity. Any modifications to the LED
emitter other than recommended changes by the manufacturer may result in these standards no longer
being met.

2. Package contents

• LED emitter LIVARNO LUX LSLB 100 A1
• Fitting materials (2 x screws and 2 x rawlplugs)
• 2 screws / 1 clamping bracket for strain relief
• Operating instructions with safety instructions
These operating instructions have a fold-out cover. On the inside of the cover is a diagram of the LED
emitter with the components numbered. The meanings of the numbers are as follows:
LED emitter
1
Movement sensor
2
TIME controller
3
LUX controller
4
SENS controller
5
Screw (with snap ring and washer)
6
Terminal box
7
Power cable fitting
8
Mounting bracket
9
Sensor housing
10
Rawlplug (2 units, for wall-mounting)
11
Screw (2 units, for wall-mounting)
12
Screw terminal
13
2 screws / 1 clamping bracket for strain relief (not shown)
20 - English