LIVARNO LUX LSLB 100 A1 Manual De Instrucciones E Indicaciones De Seguridad página 31

LIVARNO LUX LSLB 100 A1
Next, replace the cover of the terminal box (7)
and screw the 4 screws you removed earlier
back in.
Then secure the LED emitter (1) to the mounting
bracket (9) by tightening the 2 screws (6)
together with the snap rings and washers
clockwise.
At this point, you should only tighten the screws
(6) lightly.
Now line the LED emitter (1) up in the position
you want and then tighten the screws (6) fully.
Switch the power supply back on again. To do
this, replace the fuse or switch the circuit breaker
in the fusebox on (1 position).
English - 29