Net Weighing: Manual Tare Entry - Ravas 1100 Manual Del Usuario

A tare weight can be entered at any moment, meaning in either a loaded or unloaded situation.
For a higher accuracy, a tare weight can be entered with a smaller graduation step, independent
of the applied load and the active graduation of the indicator.
A tare weight larger than the so‐called MAX1 of the weighing system will not be accepted by the
indicator. The MAX1 is the value of the weight of the first range; in the standard version 200 kg
(see 3.1.). If a larger weight is keyed in, the display shows: "HELP4". Upon pressing key PT, this
HELP indication disappears.
Press the PT key.

The display shows the current tare value.

The digit on the right flashes.

Press ENTER( ) for three seconds if the current tare value is required.


Or
Press the PT key.

Press the  key to go up a value or press the  key to go down a value until the required value

is reached.
Press ENTER ( ) to change the next value.


Repeat this procedure until the required tare value is displayed.

To activate the tare weight, but without storage in the memory: press ENTER(

seconds.
The tare weight is activated.

The "NET" pointer lights up.

When the system is loaded at this moment, the net value appears in the display.

When the system is unloaded, the read‐out displays the given tare value negatively .

The keyed in value remains active until the system is turned off, a new tare weight is

entered, a new load is tared (see 3.4.) or by resetting the tare value to zero:
The weighing system is loaded: press the PT key for two seconds. The tare value is set

to zero and the system returns to the standard weighing mode.
Or
The weighing system is unloaded: press the

the system returns to the standard weighing mode.
To activate the tare weight and store it in memory: go through all the digits by pressing

ENTER( ).

The tare weight is activated and stored in the memory.

The "NET" pointer lights up.

When the system is loaded at this moment, the net value appears in the display.

When the system is not loaded, the tare value input is displayed negatively.

The keyed in value remains active, even if the system is turned off, until a new tare weight

is entered, a new load is tared (see 3.4.) or by resetting the tare value to zero:
0/T key. The tare value is set to zero and
 
‐ 10 ‐
) for three
